Ups Startup For 120V Models - Eaton Powerware Prestige Series 1500 VA Installation And Operator's Manual

Installation
Serial
Port
Air
Exhausts
Power Output
Receptacles
UPS Cabinet
External Battery Connector

UPS Startup for 120V Models

To start up the UPS for 120V models:
38 Powerware ® Prestige Series Installation and Operator's Manual for IBM Applications (650 VA - 1500 VA) Uncontrolled Copy
Breaker Input Connector (IEC 320-C14)
Battery Output
Connector
Figure 5. Typical UPS Rear Panel
1. If you are connecting the UPS to an AS/400, the QUPSDLYTIM
system value for the UPS Monitoring feature should be set. See
"UPS Monitoring" on page 54 for instructions.
2. Plug the UPS power supply cord into the input connector on
the UPS rear panel.
3. Plug the other end of the power supply cord into a grounded,
three-wire, AC receptacle that has been wired in accordance
with NEC specifications.
The UPS performs diagnostic tests and enters Normal mode
with the equipment (load) offline. The
lit. The startup should take about 15 seconds.
Battery Cable Battery Input Connector

indicator remains
Battery
Circuit Breaker
Breaker Tie
Battery Cabinet