Switching On The Power Supply - MIMAKI JV3-250 SP Operation Manual

Switching on the power supply

The device is provided with the following three different power switches.
Main power switch
Power switch
Pre-heater power switch
Main power switch
Downloaded From ManualsPrinter.com Manuals
• The plotter has two power plugs. The two power cables must be connected
to separate receptacles that are grounded separately. Connecting them to
the same power supply will lead to power failure or the plotter malfunction.
: Located on the rear face of the device. Normally, leave this switch turned on.
If this switch is left turned off, the head nozzles may be clogged. Nozzle
clogging may not be recovered depending on the symptom.
•
: Located on the front face of the device. Normally, use this switch.
Press this switch once to turn on the power of the device. Press it again to turn
off the device. Even when the power switch is off, the power is turned on
periodically and the nozzle clogging preventive function is activated.
: Located next to the main power switch on the back of the plotter.
Pre-heater power switch
When the main power switch is turned ON with the power switch
set to OFF, the nozzle clogging preventive function operates.
After operation, the power is turned OFF automatically.
- 2.3 -
Power switch