Before Taking A Phenomenon As A Sign Of Failure; The Device Cannot Be Energized; The Device Cannot Perform Printing - MIMAKI JV3-250 SP Operation Manual

Before taking a phenomenon as a sign of failure

Corrective measures against troubles in the case where no error message is given on the LCD are
described in this section. Be sure to take the following measures before taking the trouble as a sign
of failure. If the measures fail restore the device to the normal state, contact your local MIMAKI
distributor or MIMAKI office to call for service.

The device cannot be energized

More often than not, this is due to improper connection of the power cable. Check that the power
cable has been properly connected to the power outlet and the computer.
Has the power cable been
connected to the device and the
receptacle?
Is the main switch ON?
Is the power turned off immediately
after initial operation?

The device cannot perform printing

This occurs when the data is not being transmitted to the device properly. It can also occur when any
of the device functions fails or the medium has been set improperly.
Is the correct interface cable
used?
Has the interface cable been
securely connected in position?
Is the message telling that ink
has run out shown on the
display?
Downloaded From ManualsPrinter.com Manuals
No
Securely connect the power
No
cable to them.
No Turn on the power of the main
switch.
Turn on the power of the power
Y e s
switch.
Y e s
Use the cable exclusive for the
device.
Y e s
Securely connect the interface
cable in position.
No
Replace the ink cartridge with a
new one.
- 6.2 -
page 2.3
page 2.3
page 2.38