Table of Contents
Advertisement
Correcting the medium feed rate during operation
The method of correcting the medium feed rate in the LOCAL mode is explained earlier ([MEDIA
COMP.]
STEP
1. Press the [REMOTE] key.
2. Send data from the computer.
3. Start plotting.
4. Press the jog key [ ] or [ ] as needed to set
the amount of correction.
The value is incremental/ decremental to the correction value
of the current media type.
5. Press the [END] key to return to the REMOTE
display.
If the key is not pressed within 30 seconds, the menu will
return to the REMOTE display automatically.
Downloaded From ManualsPrinter.com Manuals
page 2.33).
• A new value takes effect in real time. The best
effect can be obtained while checking the result.
• The unit of the correction value is the same as in
"MEDIA COMP." in the LOCAL mode.
(
page 2-34)
- 2.35 -
∗ REMOTE ∗
TYPE. 1
0. 0 0m
∗ REMOTE ∗
3 6 0 x 3 6 0
TYPE. 1
0. 0 0m
MEDIA COMP.
1 0
MEDIA COMP.
1 0
New value
Old value
∗ REMOTE ∗
TYPE. 1
0. 0 0m
1
0
1
1
Advertisement
Table of Contents
