Table of Contents
Advertisement
Moving the device
When moving the device by necessity within the same floor without steps, perform the following
procedure.
Before moving the plotter, unlock the 7 level feet using the supplied wrench.
Method of moving the device
When moving the device, it must be held up by
at least two persons as illustrated at right.
The cover of the device may break if it is pressed hard.
Locking the level foot
Before moving the plotter, unlock the 7 level
feet using the supplied wrench.
The castors do not have stoppers. Lock all level feet before
using the plotter.
Downloaded From ManualsPrinter.com Manuals
• When moving the device to a different place, contact local representative of
Mimaki Engineering. If you move it, failure of damage may occur.
Be sure to request a specialist to move the device.
• When moving the device, take care not to apply excessive shock to it.
• After moving the device, be sure to lock the level feet.
level foot
- 1.3 -
Advertisement
Table of Contents
