Video Sg; Audio Sg; Ip Config; Ip Address - AJA Ki PRO rack Operation Manual

41.2 VIDEO SG

41.3 AUDIO SG

50.1 IP CONFIG

50.2 IP ADDRESS

Ki Pro Rack v4.2
This parameter determines the video signal output from Ki Pro's internal test signal
generator. This parameter is used with parameter 41.1 to determine the type of video
test signal output by Ki Pro Rack. These are the available options:
OFF (default)
Black
75% Bars
100% Bars
This parameter determines the audio signal output from Ki Pro Rack's internal test signal
generator. These are the available options:
OFF (default)
Silence
1 kHz
This parameter determines the type of TCP/IP network configuration used by Ki Pro Rack.
These are the available options:
STATIC ADDR
DEFAULT ADDR
DHCP (default)
NOTE: With parameters 50.1, 50.2 and 50.3, there is no timeout when editing—changes made while
in these menus are saved and activated when the menu is exited.
This parameter determines the static IP address used by Ki Pro for TCP/IP networking.
These are the available options:
variable
NOTE: For parameters 50.2, 50.3, and 50.4, you will be setting IP addresses that consist of "octets"
separated by a period (i.e., 90.0.181.0). When editing these, the Select button selects the octet
Turn test signal output OFF.
Video test signal output is color black.
Video test signal output is 75% color bars. This 75%
amplitude,100% saturation test signal is useful to check
low frequency response and video tilt as well as the
performance of video clamping.
Video test signal output is 100% color bars. This 100% white
full field bars test signal is helpful to check chroma
amplitude versus overall video level.
Turn audio test signal output OFF.
Output an audio test signal containing silence only.
Output a standard 1 kHz test signal tone.
Assign a static IP address manually (parameters 50.2, 50.3,
and 50.4 will have to be entered to accomplish this).
Use the factory default static IP address: 10.65.74.65
Select automatic IP address assignment from DHCP server on
LAN.
NOTE: if Ki Pro Rack cannot find a DHCP server to
communicate with, it will select the default factory IP
address of 192.168.0.2.
Using the adjust buttons, enter an IP address compatible with
your LAN (if you have one). If direct connecting to a
computer, enter a legal IP address that you'll also enter in
the computer's web browser. This is only needed for Static
IP configurations.
NOTE: If 50.1 is set to DHCP and there is a DHCP failure, then
the default IP address is: 192.168.0.2
NOTE: If 50.1 is set to Default Addr, the default static IP address
is: 10.65.74.65
57 www.aja.com