Audio Sg; Ip Config; Ip Address - AJA Ki Pro Installation And Operation Manual

41.3 AUDIO SG

50.1 IP CONFIG

50.2 IP ADDRESS

Ki Pro Installation and Operation Manual — CONFIG menus
41.3 AUDIO SG
This parameter determines the audio signal output from Ki Pro's internal test signal
generator.
OFF (default)
Silence
1 kHz
50.1 IP CONFIG
This parameter determines the type of TCP/IP network configuration used by Ki Pro.
Note: With parameters 50.1, 50.2 and 50.3, there is no timeout when editing—changes made
while in these menus will be saved and activated when the menu is exited.
STATIC ADDR
DEFAULT ADDR
DHCP (default)
50.2 IP ADDRESS
This parameter determines the static IP address used by Ki Pro for TCP/IP networking.
variable
Note: For parameters 50.2, 50.3, and 50.4, you will be setting IP addresses that consist of
"octets" separated by a period (i.e., 90.0.181.0). When editing these, the Select button selects
the octet and then the Adjust buttons select the desired number. Pressing Select Up again
advances to the next octet. At the final octet, the address will flash—pressing Select Up at
that point confirms the setting.
When these parameters are edited, you can abort the editing process by backing out (press
the Select down arrow button repeatedly until the edit passes the first octet). You'll notice
that after completing the edit on the last octet, the display will blink—this is an indication
that the edited IP address is about to be saved. You can save the edited IP address (press the
Select arrow up to save) or choose not to save by pressing the Select arrow down button.
Turn audio test signal output OFF.
Output an audio test signal containing silence only.
Output a standard 1 kHz test signal tone.
Assign a static IP address manually (parameters 50.2,
50.3, and 50.4 will have to be entered to accomplish
this).
Use the factory default static IP address: 10.65.74.65
Select automatic IP address assignment from DHCP
server on LAN.
Note: if Ki Pro cannot find a DHCP server to
communicate with, it will select the default factory IP
address of 192.168.0.2.
Using the adjust buttons, enter an IP address compatible
with your LAN (if you have one). If direct connecting to a
computer, enter a legal IP address that you'll also enter in
the computer's web browser. This is only needed for
Static IP configurations.
If 50.1 is set to DHCP and there is a DHCP failure, then
the default IP address is: 192.168.0.2
If 50.1 is set to Default Addr, the default static IP address
is: 10.65.74.65
51
1