Mitel 622 DECT User Manual page 60

Supplementary features
<Call routing>
Activating ring alone
You wan to specify which of your phone shall ring when you receive a call.
When your system administrator has set up a phone number with several phones (One-
number user concept, see chapter "Purpose and function", page 8), you can define on
which phones a call shall acoustically be signalled using ring alone.
When you have activated ring alone on a phone, the acoustic ringing tone is deactivated
for all other phones ( ). An incoming call is signalled in the display of all phones. You can
answer the call on each of your phones.
Note:
When you have activated ring alone but deactivated the personal call routing for a phone
in parallel, an incoming call is not acoustically but only visually signalled.
This function must be stored under a function key (see chapter "Configuring keys",
page 91).
Ring alone
Activating / deactivating room monitoring (Baby surveillance)
You want to use your cordless phone to observe acoustic monitoring tasks, for example to
monitor a toddler.
You can activate a room monitoring mode on your cordless phone. You can select
between active and passive room monitoring.
Activate the room monitoring on your cordless phone (
for room monitoring is activated after a delay of 10, 20 or 30 seconds. Use this time lag to
position the cordless phone in the room where you want e.g.to monitor your child and
leave the room.
60
Select the call routing you want and confirm with the
➔
Personal call routing is activated.
To deactivate personal call routing:
Press >
Menu Activated features
Renaming personal call routing:
Press >
Menu Settings
In the idle state:
Press the function key for
➔
Ring alone is activated/deactivated.
> Reset.
> >
General Personal call routing
Ring alone.
is displayed). The microphone
softkey.
Select
> Change.
Mitel 622 DECT Phone
eud-1720/1.0 – R3.0 – 08.2015