Carry Clip Or Swivel Clip - Mitel 622 DECT User Manual

Installation and first-time operation
Charging the battery
The batteries are supplied uncharged. To charge the batteries, place the phone in the
charging unit.
It is only after the battery has been charged for the first time that your phone is ready for
use, that calls can be answered and that you can make calls from the phone.
Notes:
• It takes several charging cycles before a new battery reaches full capacity.
• The technical data can be found in the chapter "Technical data", page
• The descriptions of the display symbols can be found in the chapter "Display symbols",
18
page .
• Poor radio links (sizeable distance to the system's radio station) will reduce the phone's
standby and talk times. The standby and talk times are also reduced by high louds-
peaker or ring tone volumes, frequently used keypad and display backlighting, and acti-
vated vibra alarms and Bluetooth mode.

Carry clip or swivel clip

Fitting / removing the carry clip or swivel clip
The carry clip supplied with the phone is placed on the two openings at the top end of the
phone and pressed in until it snaps into place. To remove the carry clip, press the small
recesses on the edge of the strap and gently pull the strap apart.
The phone can also be equipped with a swivel clip accessory. The holding clip is also
placed on the two openings at the top end of the phone and pressed in until it snaps into
place. Next slide the clip onto the prominent button. To release the phone from the clip,
press the upper button.
102
108
.
Mitel 622 DECT Phone
eud-1720/1.0 – R3.0 – 08.2015