Throttle Position Sensor (Tps) - Arctic Cat PROWLER HDX 2015 Service Manual

OUTPUT VOLTAGE
NOTE: Needle adapters will be required on the
multimeter leads as the following tests are made
with the sensor connected.
1. Connect the three-wire plug to the sensor; then
remove the right-side mounting screw securing the
sensor to the rear frame.
2. Install the needle adapters to the multimeter leads;
then select DC Voltage on the multimeter.
3. Connect the red tester lead to the blue/brown wire
(B) and the black tester lead to the black/yellow wire
(A); then turn the ignition switch ON and observe the
meter. The meter should read 0.8-3.0 DC volts (700)
or 0.3-1.5 DC volts (500).
4. Tilt the sensor 60° or more to the left and right
observing the meter. The meter should read 4.0-8.0
DC volts (700) or 3.0-7.0 DC volts (500) after
approximately one second in the tilted position. If
the meter readings are not as specified, the tilt sensor
is defective.
NOTE: When replacing the sensor after testing,
make sure the arrow marking is directed up.
CD707
Throttle Position Sensor
Component data can be retrieved using the CATT II. Uti-
lize the Sensor Data screen.

CD705B
NOTE: Preliminary checks may be performed on
this component using the diagnostic mode on the
LCD gauge (see EFI Diagnostic System in this sec-
tion).
TESTING
1. Remove the left-side engine cover; then disconnect
the three-wire TPS connector plug.

NOTE: Prior to testing the TPS, inspect the three-
wire plug connector on the main harness and the
three-pin plug on the TPS for contamination, broken
pins, and/or corrosion.
(TPS)
CD709
CD705A
143