Chapter 5. Removing And Installing Components; Removing And Installing The Chassis Door; Time And Items Required; Removing The Chassis Door - IBM System Storage SAN384B-2 Installation, Service And User Manual

Chapter 5. Removing and installing components

Attention: Read the safety notices before servicing (see "Safety notices and
labels" on page xv).
The field replaceable units (FRUs) in the SAN384B-2 can be removed and installed
without special tools. The SAN384B-2 can continue operating during many of the
FRU replacements if the conditions specified in the procedures are followed.
Attention: The system contains electrostatic discharge (ESD) sensitive FRUs.
When working with any FRU, follow ESD precautions (see "ESD precautions" on
page xxi).
The sections contain FRU removal and installation procedures.
v "Removing and installing the chassis door"
v "Removing and installing cable management finger assemblies" on page 68
v "Removing and installing port, application, and encryption blades" on page 70
v "Removing and installing blade filler panels" on page 72
v "Removing and installing a CP8 control processor blade" on page 73
v "Removing and installing a CR16-4 core switch blade" on page 82
v "Removing and installing a power supply" on page 84
v "Removing and installing a blower assembly" on page 86
v "Removing and installing a WWN bezel and WWN card" on page 88
v "Removing and installing transceivers" on page 90
v "Removing and replacing inter-chassis link (QSFP) cables" on page 93
v "Removing and replacing a SAN384B-2 chassis" on page 98

Removing and installing the chassis door

Note: The chassis door must be installed to ensure the SAN384B-2 meets EMI and

Time and items required

The replacement procedure for the chassis door takes less than 5 minutes.

Removing the chassis door

Complete the steps to remove a chassis door.
1. Support the door to prevent it from falling.
2. Pull and remove the door. It will pop off the ball studs.
Complete the steps to install a chassis door.
1. Align the holes on the back of the door with the ball studs on the chassis
2. Push the door into place. It will snap onto the studs. See Figure 31 on page 68.
© Copyright IBM Corp. 2011, 2013
other regulatory certifications. Additionally, if ICL cables are not used, EMI
plugs must be inserted in the ICL cable ports to meet certification standards.
67