Installing A Cable Management Finger Assembly; Cable Management Finger Assemblies - IBM System Storage SAN384B-2 Installation, Service And User Manual

Figure 32. Cable management finger assemblies

Installing a cable management finger assembly

Complete the steps to install a cable management finger assembly.
1. Position the vertical cable management finger assembly along the upright rails
of the rack, aligning the holes on the assembly with the holes in the SAN384B-2
chassis.
2. Insert and tighten the two screws to secure the cable management assembly to
the rack's vertical rails.
Note: Three screws secure the chassis to the cabinet vertical rails, two of which
are also used to secure the cable management assembly. The holes on the
assembly will only match two of the holes on the chassis at a time. This
will allow the cable management assemblies to be mounted either
towards the top or towards the bottom of the chassis, depending on
cable density and cable routing.
3. Arrange the cables through the fingers of the cable management assembly.
4. Repeat steps 1-3 for the other cable management assembly.
5. Replace the chassis door.
Chapter 5. Removing and installing components
69