Removing And Installing Cable Management Finger Assemblies; Time And Items Required; Removing A Cable Management Finger Assembly - IBM System Storage SAN384B-2 Installation, Service And User Manual

Figure 31. Chassis door

Removing and installing cable management finger assemblies

The SAN384B-2 comes equipped with two vertical cable management finger
assemblies. It can continue to operate during the replacement of the cable
management assemblies. Due to the horizontal orientation of the blades, the cable
management assemblies are attached to the uprights of the mounting rack.

Time and items required

The replacement procedure for the cable management fingers takes less than five
minutes. A #1 Phillips screwdriver is required.

Removing a cable management finger assembly

Complete the steps to remove the cable management finger assembly.
1. Remove the chassis door.
2. Remove the cables from the cable management finger assembly and rearrange
3. Unscrew and save the two screws that attach the cable management assembly
4. Remove the cable management assembly.
5. If necessary, repeat steps 2-4 for the other cable management assembly.
68
SAN384B-2 Installation, Service, and User Guide
the cables around the assembly.
to the rack upright (see Figure 32 on page 69). Support the assembly to prevent
it from falling.
384b015