Removing A Blower Assembly; Installing A Blower Assembly; Blower Assembly Removal And Replacement - IBM System Storage SAN384B-2 Installation, Service And User Manual

Removing a blower assembly

Complete the steps to remove a blower assembly.
1. Before removing a blower assembly, verify that the other blower assembly is
functioning correctly. The power LEDs should be steady green.
2. Use the screwdriver to loosen the captive screws at the left and right edges of
the blower assembly.
3. Grasp the handle and pull, sliding the blower assembly from the chassis and
supporting the blower assembly from beneath as you remove it (see Figure 39).
Figure 39. Blower assembly removal and replacement

Installing a blower assembly

complete the steps to install a blower assembly.
1. Orient the blower assembly in front of the open slot and slide it into the
chassis, pushing firmly to ensure that it is seated.
2. Verify that the power LED displays a green light.
3. Use the screwdriver or your fingers to tighten the captive screws.
Chapter 5. Removing and installing components
87