Downloading The Configuration - IBM System Storage SAN384B-2 Installation, Service And User Manual

10. Connect the power cords to the power supplies and the power outlets.
11. Replace the chassis door ("Removing and installing the chassis door" on page
12. Power on the system ("Providing power to the SAN384B-2" on page 35).
13. Verify that the SAN384B-2 is powered on and POST is complete (all power
14. Verify that all components are functioning correctly by checking their LEDs. If

Downloading the configuration

Once the chassis and its various components have been reassembled and powered
back on, use the configDownload command to restore the original configuration.
The configDownload command can be entered through a Telnet or serial session,
but the SAN384B-2 must have an Ethernet connection to the server name or IP of
the host for the download process to complete. For more information, refer to the
help configdownload command or the Fabric OS Command Reference.
To download the configuration, complete the steps.
1. Log in to the SAN384B-2 as admin:
2. Enter the chassisDisable command.
3. Enter configDownload -all command.
4. Reboot the SAN384B-2.
106
SAN384B-2 Installation, Service, and User Guide
4. Install the control processor blades ("Installing a control processor blade
(CP8)" on page 77).
5. Install the core switch blades ("Installing a CR16-4 core switch blade" on page
83).
6. If ICL cables are not used, insert rubber plugs into the QSFP transceivers if
installed in the core switch blades (CR16-4).
7. Replace the port and application blades or filler panels ("Installing a blade"
on page 72 and "Installing a filler panel" on page 73).
8. If the chassis is not yet installed in the rack, follow the steps in "Installing the
SAN384B-2 into the cabinet" on page 25.
9. Replace the cable management fingers ("Installing a cable management finger
assembly" on page 69).
67)
The system performs a power-on self-test (POST). The POST takes a minimum
of three minutes and is complete when LED activity returns to standard state.
LED indicators on the port, control processor, and core switch blades should
be a steady green).
the LEDs do not indicate correct operation, try reinstalling the corresponding
component.
switch:admin> login
login: admin
password: xxxxxxxx
switch:admin>
Note: If you are using the virtual fabric feature, you must run
configDownload -vf before running the configDownload command in
order to restore the logical switch configuration.
switch:admin> configdownload -all
Server Name or IP Address [host]: 123.123.123.123
User Name [None]: Admin24
File Name [config.txt]: config-switch.txt
Password: xxxxxxxx
download complete
switch:admin>