Removing And Installing A Cable Management Comb; Time And Items Required; Removing A Cable Management Comb - IBM SAN768B Installation, Service And User Manual

Figure 29. Chassis door

Removing and installing a cable management comb

The SAN768B can continue to operate during the replacement of the cable
management comb.

Time and items required

The replacement procedure for the cable management comb takes less than 5
minutes. A #1 Phillips screwdriver is required.

Removing a cable management comb

To remove the cable management comb, do the following:
1. Remove the chassis door ("Removing and installing the chassis door" on page
2. Remove the cables from the cable management comb and rearrange around the
3. Unscrew and save the four screws holding the comb to the chassis (see
4. Remove the cable management comb.
70
SAN768B Installation, Service, and User Guide
69).
comb.
Figure 30 on page 71). Support the comb to prevent it from falling.