Changing The Number Plate Bulbs - Seat Ateca 2020 Owner's Manual

Unlock the securing tabs from the bulb
–
›››
holder Fig. 62 or turn the bulb holder
1
to the left and .
2 3
Remove the bulb holder from its location.
–
Lightly press the defective bulb into the
–
bulb holder, then turn it to the left and re-
move it.
Fit the new bulb, pressing it into the bulb
–
holder and turn it to the right as far as it will
go.
Use a cloth to remove any fingerprints from
–
the glass part of the bulb.
Check that the new bulb works properly.
–
Carry out the same actions in reverse order
–
for assembly and pay special attention to
placing the bulb holder, ensuring that the
tabs are properly secured.
Note
For LED pilots, you can only change the re-
verse bulb.
66
Emergencies

Changing the number plate bulbs

In the rear bumper: Number plate light.
Fig. 63
number plate light: remove the bulb
Fig. 64
holder.
Follow the steps indicated:
Press the number plate light in the direction
–
›››
of the arrow Fig. 63.
Detach the number plate light.
–
›››
Turn the connector lock Fig. 64
–
rection of arrow and pull on the connec-
1
tor.
Rotate the bulb holder in the direction of
–
›››
the arrow Fig. 64 and extract it to-
2
gether with the bulb.
Replace the faulty bulb with a new identical
–
bulb.
Insert the bulb holder into the number plate
–
light and rotate all the way in the opposite
›››
direction to the arrow Fig. 64
Plug the connector into the bulb holder.
–
Insert the number plate light carefully into
–
the opening on the bumper. Ensure that the
number plate light is in the correct position.
Insert the number plate light into the bump-
–
er until it audibly clicks into place.
in the di-
.
2