Setting The Set Point (Sp); Changing The Sp - Omron E5AZ User Manual

Setting the Set Point (SP)

3-6

Setting the Set Point (SP)

Operation level
C 20
0
3-6-1

Changing the SP

Operation Procedure
1,2,3...
Operation level
C
30
0
C 30
200
32
The "operation level" is displayed when the E5AZ/E5EZ is turned ON. The
upper display (No.1 display) displays the process value, and the lower display
(No.2 display) displays the set point.
• The set point cannot be changed when the "operation/adjustment protect"
parameter is set to "3". For details, see 4-9 Using the Key Protect Level.
• To change the set point, press the
eter (operation level), and set the desired set value. The new set point is
selected two seconds after you have specified the new value.
• Multi-SP is used to switch between two or four set points.
See 4-5 Using Event Inputs for details.
In this example, let's change the set point from "0 ° C" to "200 ° C".
1. Normally, the "PV/SP" parameter is displayed. The set point is "0 ° C".
key until the set point changes to "200 ° C".
2. Press the
Section 3-6
or key in the "PV/SP" param-