Omron E5AZ User Manual page 138

Advanced Function Setting Level
MB command logic
rlrV
switching
Function
Setting
See
a1on
Alarm 1 ON delay
a2on
Alarm 2 ON delay
a3on
Alarm 3 ON delay
a1of
Alarm 1 OFF delay
a2of
Alarm 2 OFF delay
a3of
Alarm 3 OFF delay
• Switches the logic of MB command (communications writing switching) in
the SYSWAY communications procedures.
• The MB command (communications writing switching) is equivalent to the
MB command (remote/local switching) on the E5@J.
• The hatched setting is the default (same logic as E5@J).
Setting Value
OFF Communications writing enabled
(remote mode selection)
ON Communications writing dis-
abled (local mode selection)
(Terms in parentheses () are the terms used on the E5@J.)
■ Related parameters
"Communications writing" (adjustment level) (page 87)
• This parameter is used to set the output delay for Alarm 1, 2, and 3.
• Output's delayed activation and shutdown can be respectively set.
Setting Range
0 to 99
Alarm type must be set as any type other than 0.
• Related parameters
"Alarm 1, 2, and 3 type" (initial setting level) (page 101 and 102)
Communications function must be
supported.
Text Data of MB Command
0000
Alarm1, 2, 3 type is not "0: Without
alarm function"
Units Initial Value
Seconds 0
Section 5-6
0001
Communications writing dis-
abled (local mode selection)
Communications writing enabled
(remote mode selection)
119