Initial Setting Level
Direct/reverse operation
Function
Setting
Alarm 1 type
Function
Setting
See
• "Direct operation" refers to control where the manipulated variable is
increased according to the increase in the process value. Alternatively,
"reverse operation" refers to control where the manipulated variable is
increased according to the decrease in the process value.
Setting Range
or-r: Reverse operation /or-d: Direct operation
• Select one of the following alarm 1 types:
Deviation/Deviation range/Absolute value
Refer to the alarm type list on the following page.
■ Related parameters
"Alarm value 1" (operation level)
"Alarm value upper limit 1" "Alarm value lower limit 1" (operation level)
"Standby sequence reset" "Alarm 1 open in alarm" "Alarm 1 hysteresis"
"Alarm 1 latch" (advanced function setting level)
Section 5-5
Default
or-r
The alarm 1 type must be supported.
101