Setting The Set Point (Sp); Changing The Sp - Omron E5CSV User Manual

3.5 Setting the Set Point (SP)

■ Changing
the
SP
Operating Procedure
Power ON
Process
OUT
3 value (PV)
2
SP ALM ALM 1 2
M
SP mode
OUT
Set point
0
SP ALM ALM 1 2
U + D
OUT
2 0 0
SP ALM ALM 1 2
The operation level is displayed when the power is turned ON. When
the M Key is used to light the SP indicator in the display, the set point
is displayed.
To change the set point, press the U or D Key while SP is lit on the
•
display, and set the desired set value. The new set point is selected
two seconds after the new value is specified.
•
The set point cannot be changed when the protect switch is ON.
• The setting window for the set point (SP mode) can be set as the
default window when the power is turned ON using the "PV/SP
display" parameter in the initial setting level (1).
In this example, the set point is changed from 0°C to 200°C.
1.
Display the set point (SP mode) using the M Key.
2.
Use the U and D Keys to set the set point to 200.

3.5 Setting the Set Point (SP)

3-7