Connector Information - Icom IC-F8101 Instruction Manual

6
CONNECTION AND INSTALLATION

■ Connector information

ACC Pin Pin name
11 15
6 10
1 5
ATU Pin Pin name
6 9
1 5
84
1 CI-V —
2 AF IN Input terminal for the AF signal.
3 AF OUT Output terminal for the AF signal.
4 AF GND Ground line for the AF signal.
Input terminal for receive data from GPS
5 GPS RXD
unit.
6 NC —
7 RELAY Goes to ground when transmitting.
8 EALC ALC voltage input.
PTT input terminal.
9 MODPTT
When grounded, transmits.
10 CW KEY CW and FSK keying input.
11 EALARM Output terminal for the Alarm signal.
12 GND Connect to ground.
13 5V 5 V output for GPS unit.
14 NC —
15 13.8V 13.8 V output for external equipment.
1 KEY Key signal input.
2 START Start/bypass signal output.
3 13.8V 13.8 V output for Antenna tuner.
4 13.8V 13.8 V output for Antenna tuner.
5 GND Connect to ground.
6 GND Connect to ground.
7 NC —
8 NC —
9 NC —
Description
Description
Specification
—
Input sensitivity (Data mode):
More than 52.5 W at 100 mV
Output level: 200 to 400 mVrms
when receiving Data mode
—
NMEA0183
—
Less than 100 mV
Control sensitivity (at –3 V input):
More than 40 dB suppression
Input voltage: Less than 0.8 V
for transmit
CW: Less than 0.6 V for transmit
RTTY: Open=Mark
Output current: 12 mA±10%
Open collector
—
5 V, maximum 200 mA
—
13.8 V, maximum 1 A
Specification
—
—
13.8 V, maximum 2 A
13.8 V, maximum 2 A
—
—
—
—
—