Scan Set Mode - Icom IC-F8101 Instruction Manual

5
MENU SCREEN
D Setmode (Continued)
 Scan Set mode
Type
Set the scan type to "Call," "S-Meter," "Voice" or "All
Memory."
CALL: Call Scan. It scans the channels that
belong to the network group whose
scan type is "Call."
If your station ID is called with a Sel-
call or ALE call, the scan stops on that
channel and the voice squelch control
function is activated.
S-Meter: S-Meter Scan. It scans the chan-
nels that belong to the network group
whose scan type is "S-Meter."
If the transceiver detects a signal
whose S-meter level is higher than the
Meter Squelch Level setting, the scan
stops on that channel.
Voice: Voice Scan. It scans the channels that
belong to the network group whose
scan type is "Voice."
If the transceiver detects voice compo-
nents, the scan stops on that channel.
All Memory: All Memory Scan. It scans all memory
channels.
If the transceiver detects a signal
whose S-meter level is higher than the
Meter Squelch Level setting, the scan
stops on that channel.
Voice Scan Resume
Set the scan resume function to ON or OFF for an S-
Meter, Voice or All Memory scan, and set the pause
timer to between 5 seconds and 120 seconds, in 5
second steps.
When this setting is ON and a signal is detected, a
scan pauses for this set period, then resumes, or re-
sumes 2 seconds after the signal disappears.
If OFF is selected, the scan pauses until the signal
disappears.
All Memory Scan Speed
Set the scan speed for the All Memory scan to LOW,
MID or HIGH.
68
(Default: Call)
(Default: 10sec)
(Default: HIGH)
(Default: Call)
(Default: 10sec)
(Default: HIGH)