Mode Screen - LevelOne WBR-6010 User Manual

Setup

Mode Screen

This page allows you to switch the WBR-6010 between Wireless Router and Access
Point configurations.
Modes
Router
Access Point
Figure 7: Wireless Screen
In this mode, this device can provide shared Internet Access to
all your LAN users. Also, by default, it acts a DHCP Server,
providing an IP address and related information to all Wireless
and LAN users.
It is the default mode of the WBR-6010.
In this mode, the unit does not perform any changes to the
network traffic passing through it. It is used purely to relay the
wireless traffic. You‟ll need to have a DHCP Server on your LAN
to provide IP addresses to the Wireless and LAN clients using
this Access Point.
This mode can be used as a second wireless access point to
extend and relay the wireless signal over a greater area.
IP Address: Set the IP Address of the WBR-6010, when
used as an Access Point. Be careful not to
conflict with existing IP Addresses.
Subnet Mask: Enter the Subnet Mask that matches that used
in your other LAN devices.
21