Table of Contents
Advertisement
Front Panel Display Management
Unit Configuration Options
Users may perform the following configurations to the device:
• LOOP DETECT
• CONSOLE LOCK
• NETWORK CONFIGURATION
• IP ADDRESS
• SUBNET MASK
• DEFAULT GATEWAY
• SET PASSWORD
• SYSTEM RESTART
• SYSTEM DEFAULT (i.e. Factory Reset)
User Authentication
To enter the Unit Configuration menu, user authentication is required when
the system is locked. The user will be prompted to enter the password. The
password is composed of four numeric digits represented by the four
asterisks as shown in Figure 3.29. The factory default password is "0000".
Press Enter. In the UNIT CONF menu You will briefly see the SYS
LOCKED message, then the password request.
Figure 3.29 Password Verification
Press Prev to select the first digit.
3-29
Advertisement
Table of Contents
