Table of Contents
Advertisement
4-2
Setting-Up for Console Management
C h a p t e r 4 Setting-Up for Console Management
Managing The Switch
Several parameters of the Switch must be configured before you are able to
access it via a Telnet session, the Web-Based Management interface or
SNMP. The parameters include the IP address, subnet mask and default
gateway. These parameters can be configured via the Front Panel Display or
the Console program, which is accessed through a PC terminal emulation
program that supports VT100.
The Switch can be managed through the Console Program, Telnet, Web
Management or SNMP. This chapter describes setting up for management,
which is done through the Console program.
Console Program
To configure the system, connect an EIA-232 serial cable to a COM port on a
PC or notebook computer and to the Console Port of the Switch as shown in
the following figure.
Advertisement
Table of Contents
