Table of Contents
Advertisement
Installation
Installing Optional Modules
Power down Switch before installing an optional module. No hardware or
software configuration settings are required. Please read this section carefully
before installing modules.
To install an option module, perform the following steps.
Note: Modules are not hot-swapable. You must remove power from the
switch before installing or replacing a module.
1.
Remove the power from the Switch by disconnecting the power
cable from the AC outlet.
2.
Remove blank cover from the module slot by turning the two
knobs on the front counterclockwise as shown in Figure 2.2.
Figure 2.2 Removing the Blank Module Panel
3.
Insert the new module, ensuring that the edges slide through the
guides, as shown in Figure 2.3
2-3
Advertisement
Table of Contents
