Table of Contents
Advertisement
2-4
4.
Turn the two knobs on the new module until they are securely
attached to the Switch.
5.
Connect AC power to the switch.
6.
Connect the appropriate communication cable to the new
module.
Quick Configuration
Three basic parameters must be set in order to configure the Switch into your
network. The parameters include the IP address, subnet mask and default
gateway. These parameters can be configured via the Front Panel Display or
the Console Management program.
The following two sections provide you with brief configuration instructions
using the Front Panel Display and the Console Management program. For
more detailed instruction, please refer to the appropriate subsequent chapters.
Figure 2.3 Insert the Module
Installation
Advertisement
Table of Contents
