Table of Contents
Advertisement
TROUBLESHOOTING
ENGINE DOES NOT TURN
1. Ignition switch is in the OFF position.
–
Place switch to the ON position.
2. Engine stop switch
–
Make sure that the engine stop switch is in ON position.
3. Transmission is not set on NEUTRAL.
–
Set transmission in NEUTRAL and apply brakes (front or rear).
4. Brakes are not applied
–
Apply brakes (front or rear) and set transmission in NEUTRAL.
5. Burnt fuse.
–
Check main fuse condition.
6. Weak battery or loose connections.
–
Check charging system fuse.
–
Check connections and terminals condition.
–
Have the battery checked.
–
Contact an authorized Bombardier ATV distributor/dealer.
ENGINE TURNS OVER BUT FAILS TO START
1. Mixture not rich enough to start cold engine.
–
Check fuel tank level and check starting procedure, particularly use of the
choke.
2. Flooded engine (spark plug wet when removed).
–
Refer to SPECIAL PROCEDURES.
3. No fuel to the engine (spark plug dry when removed).
–
Check fuel tank level; turn fuel valve to ON (also try on RES). A failure of
the fuel pump or carburetor may have occurred.
–
Contact an authorized Bombardier ATV distributor/dealer.
4. Spark plug/ignition (no spark).
–
Check main fuse condition.
–
Remove spark plug then reconnect to spark plug cap.
–
Check that ignition switch and/or engine stop switch is/are at the ON posi-
tion.
–
Start engine with spark plug grounded to the engine away from spark plug
hole. If no spark appears, replace spark plug.
–
If trouble persists, contact an authorized Bombardier ATV distributor/dealer.
______________________
88
Hide quick links:
Advertisement
Table of Contents
