Telnet Command: Ip6 Dhcp Req_Opt - Draytek Vigor2925 Series User Manual

-d
-a
-u
prefix
prefix-length
LAN|WAN1|WAN2|iface#
E E x x a a m m p p l l e e
> ip6 addr -a
LAN
Unicast Address:
FE80::250:7FFF:FE00:0/64 (Link)
Multicast Address:
FF02::2
FF02::1:FF00:0
FF02::1
T e l n e t C o m m a n d
T e l n e t C o m m a n d
This command is used to configure option-request settings for DHCPv6 client.
ip6 dhcp req_opt [LAN|WAN1|WAN2|iface#] [-<command> <parameter>| ... ]
S y n t a x D e
S y n t a x D e
Parameter
req_opt
LAN|WAN1|WAN2|iface#
[<command>
<parameter>|...]
-a
-s
-S
-d
-D
-n
-i
-I
-p
-P
-b
It means to delete an ipv6 address.
It means to show current address(es) status.
It means to show only unicast addresses.
It means to type the prefix number of IPv6 address.
It means to type a fixed value as the length of the prefix.
It means to specify LAN or WAN interface for such address.
: i p 6 d h c p r e q _ o
: i p 6 d h c p r e q _ o
s c r i p t i o n
s c r i p t i o n
Description
It means option-request.
It means to specify LAN or WAN interface for such address.
The available commands with parameters are listed below.
[...] means that you can type in several commands in one
line.
It means to show current DHCPv6 status.
It means to ask the SIP.
It means to ask the SIP name.
It means to ask the DNS setting.
It means to ask the DNS name.
It means to ask NTP.
It means to ask NIS.
It means to ask NIS name.
It means to ask NISP.
It means to ask NISP name.
It means to ask BCMCS.
p t
p t
559
Vigor2925 Series User's Guide