Telnet Command: Ip Addr - Draytek Vigor2925 Series User Manual

IP
Join to NAT Pool
index
E x a m p l e
E x a m p l e
> ip aux add 192.168.1.65 1
% 192.168.1.65 has added in index 2.
> ip aux ?%% ip aux add [IP] [Join to NAT Pool]
%% ip aux remove [Index]
%% Where IP = Auxiliary WAN IP Address.
%%
%%
Now auxiliary WAN1 IP Address table:
Index no.
----------------------------------------------------
1
2
When you type ip aux?, the current auxiliary WAN IP Address table will be shown as the
following:
Index no.
----------------------------------------------
1
2
3
T e l n e t C o m m a n d
T e l n e t C o m m a n d
This command allows users to set/add a specified LAN IP your router.
ip addr [IP address]
S y n t a x D e
S y n t a x D e
Parameter
IP address
E x a m p l e
E x a m p l e
>ip addr 192.168.50.1
% Set IP address OK !!!
Note: When the LAN IP address is changed, the start IP address of DHCP server are still the
same. To make the IP assignment of the DHCP server being consistent with this new IP
address (they should be in the same network segment), the IP address of the PC must be fixed
with the same LAN IP address (network segment) set by this command for accessing into the
web user interface of the router. Later, modify the start addresses for the DHCP server.
It means the auxiliary WAN IP address.
0 (disable) or 1 (enable).
Type the index number of the table displayed on your screen.
Join to NAT Pool = 0 or 1.
Index = The Index number of table.
Status IP address
Disable 0.0.0.0 Yes
Enable 192.168.1.65
Status IP address
Enable 172.16.3.229
Enable 172.16.3.56
Enable 172.16.3.113
: i p a d d r
: i p a d d r
s c r i p t i o n
s c r i p t i o n
Description
It means the LAN IP address.
NAT IP pool
Yes
IP pool
Yes
No
No
543
Vigor2925 Series User's Guide