Telnet Command: Srv Nat Dmz; Telnet Command: Srv Nat Ipsecpass - Draytek Vigor2925 Series User Manual

T e l n e t C o m m a n d
T e l n e t C o m m a n d
This command allows users to set DMZ host. Before using this command, please set WAN IP
Alias first.
Srv nat dmz n m [-<command> <parameter> | ... ]
S y n t a x D e
S y n t a x D e
Parameter
n
m
[<command>
<parameter>|...]
-e
-i
-r
-v
E x a m p l e
E x a m p l e
> srv nat dmz 1 1 -i 192.168.1.96
> srv nat dmz -v
% WAN1 DMZ mapping status:
Index Status WAN1 aux IP
----------------------------------------------------
1 Disable 0.0.0.0 192.168.1.96
T e l n e t C o m m a n d
T e l n e t C o m m a n d
This command allows users to enable or disable IPSec ESP tunnel passthrough and IKE
source port (500) preservation.
Srv nat ipsecpass [options]
S y n t a x D e
S y n t a x D e
Parameter
[options]
on
off
: s r v n a t d m z
: s r v n a t d m z
s c r i p t i o n
s c r i p t i o n
Description
It means to map selected WAN IP to certain host.
1: wan1
2: wan2
It means the index number (1 ~ 8) of the DMZ host.
Default setting is "1" (WAN 1). It is only available for Static
IP mode. If you use other mode, you can set 1 ~ 8 in this
field. If WAN IP alias has been configured, then the number
of DMZ host can be added more.
The available commands with parameters are listed below.
[...] means that you can type in several commands in one
line.
It means to enable/disable such feature.
1:enable
0:disable
It means to specify the private IP address of the DMZ host.
It means to remove DMZ host setting.
It means to display current status.
: s r v n a t i p s e c p
: s r v n a t i p s e c p
s c r i p t i o n
s c r i p t i o n
Description
The available commands with parameters are listed below.
It means to enable IPSec ESP tunnel passthrough and IKE
source port (500) preservation.
It means to disable IPSec ESP tunnel passthrough and IKE
Private IP
a s s
a s s
621
Vigor2925 Series User's Guide