1. When you select INT from the Craft Local Procedure Screen, the following text
2. To change the Ethernet setting, press the Right navigation arrow to cycle through
3. To change the PC Ethernet setting, select that line and press the Right navigation
4. Press Save to store the new setting(s) and redisplay the Craft Local Procedure
H.323 Installation & Maintenance Guide R6.1
displays with a prompt to use the Right and Left navigation arrows to select a setting:
Ethernet
PC Ethernet
The values shown are the text strings associated with the current PHY1STAT on
the Ethernet line and the current PHY2STAT system value on the PC Ethernet
line.
The PHY1STAT text strings are:
• Auto when PHY1STAT = 1
• 10Mbps half when PHY1STAT = 2
• 10Mbps full when PHY1STAT = 3
• 100Mbps half when PHY1STAT = 4
• 100Mbps full when PHY1STAT = 5
• 1000Mbps full when PHY1STAT = 6
The PHY2STAT text strings are:
• Disabled when PHY2STAT = 0
• Auto when PHY2STAT = 1
• 10Mbps half when PHY1STAT = 2
• 10Mbps full when PHY1STAT = 3
• 100Mbps half when PHY1STAT = 4
• 100Mbps full when PHY1STAT = 5
• 1000Mbps full when PHY1STAT = 6
the possible settings.
Depending on the current value, the next sequential text string is selected and
displayed as the setting. For example, if the current value is 10Mbps half (2),
pressing the Right navigation arrow changes the value to 10Mbps full (3). If the
current value is 1000Mbps full (6), pressing the navigation arrow changes the value
to Auto (1).
arrow to cycle through the possible settings.
screen.
Changing Ethernet interface control
Choice Selector
Choice Selector
May 2011
51