Avaya 9608 Installation And Maintenance Manual page 29

5. The IP telephone sends a request to the DHCP server and invokes the DHCP
6. Determination of the DHCP protocol (IPv4 or IPv6) is done, and the applicable
7. Using the list of gateway IP Addresses provided by the DHCP server, the telephone
H.323 Installation & Maintenance Guide R6.1
access to local procedures. If PROCSTAT is "1" the Craft Access entry procedure
can be invoked only when a "
procedure is available. For information, see
Options on page 33
process.
One of the following messages displays:
DHCP: s secs * to program
or
DHCP: s secs VLAN ID = n
or
DHCP: s secs
where s is the number of seconds that have elapsed since DHCP was invoked. The
first messageappears if 802.1Q tagging is off and access to local programming
procedures is not disabled or restricted. (See
Options on page 33 for specifics.) The middle message appears if 802.1Q tagging
is on and access to local programming procedures is disabled or restricted. If the
first and middle messages alternate every two seconds, 802.1Q tagging is on. When
both messages alternate, access to local programming procedures is not disabled
or restricted. Finally, the third message appears if 802.1Q tagging is off and access
to local programming procedures is disabled or restricted.
parameters enabled.
Important:
IPv6 operation is limited to a specific customer set and not for general use.
Note:
The IPV6STAT parameter overrides both the DHCPSTAT parameter setting and
manual programming, therefore if DHCPSTAT is set to enable DHVPv6, it will be
disabled if IPV6STAT is "0" (disabled). Manual programming overrides
DHCPSTAT, therefore even if DHCPSTAT is set to enable DHCPv4 or DHCPv6,
the DoDHCPV4 or DoDHCPV6 will be set to "0" (disabled) if an IP Address of the
corresponding type has been manually programmed.
The DHCP server provides IP Addresses for the following hardware:
• The IP telephone
• The HTTP/HTTPS server
• The TN799C or D Control-LAN (C-LAN) circuit pack on the media server
performs a router check. The telephone cycles through the gateway IP Addresses
with ARPs or pings until it receives a response. When the router is located, received
LLDP TLVs are processed. Then the HTTP process starts.
How the power-up and reset process works
" message displays but only the VIEW
* to program
Using Local Administrative (Craft)
Using Local Administrative (Craft)
May 2011 29