Avaya 9608 Installation And Maintenance Manual page 44

Using Local Administrative (Craft) Options
2. Use the navigation arrows to scroll to and highlight the address you want to change,
3. Depending on the item you selected, choose one of the following:
44 H.323 Installation & Maintenance Guide R6.1
• dddd is the current value of NVL2QVLAN and ddd is the current value of
NVVLANTEST, respectively.
then press Change to display the change screen for that specific address value.
If you want to
Change any of the IP
Address values
(Phone, Call Server,
Router, Mask, &/or
File Server)
Change the 802.1Q
value
Change the VLAN ID
value
Then
Use the dialpad to enter the new IP Address. IP
Addresses have three sets of three digits followed by a
period. Pressing * (asterisk) following entry of three digits
causes a period to be placed in the next position, and
the cursor to advance one position to the right. If the
asterisk dialpad button is pressed and the user is
entering an IPv6 address, a colon is inserted into the
input buffer and the cursor is moved to the next character
location; the exceptions are entry of a Router or Mask
address, which follows the IPv4 method of inserting a
period rather than a colon. In addition to the examples
that follow, entry and validation of addresses in either
format is described in About entering and validating IPv4
and IPv6 addresses on page 37. For example, to enter
the IP Address 111.222.333.444 in IPv4 format, press
the number 1 on the dialpad three times then press *,
press the number 2 on the dialpad three times then press
*, press the 3 on the dialpad three times then press *,
then press the 4 on the dialpad three times.
To enter an IP Address in IPv6 format the dialpad uses
numeric-only entry (single-tap the desired dialpad key
for touchscreen telephones), except for "2" and "3" which
are alphanumeric (multi-tap for touchscreen
telephones). For example, pressing button "2" initially
enters a "2", followed by "A", "B", "C", and back to "2".
Pressing button "3" initially enters a "3", followed by "D",
"E", "F", and back to "3".
Proceed to the next step.
Use the Right navigation arrow to cycle through the text
strings corresponding to the L2Q values defined as
"Auto" if L2Q=0, "On" if L2Q=1, and "Off" if L2Q= 2 until
the text string of the value you want to change to
displays. Proceed to the next step.
Use the dialpad to enter the new static VLAN ID of from
0 to 4094, inclusive. Proceed to the next step.
May 2011