Flexible Storage Compartment; Floor Covering On Both Sides; Luggage Compartment Cover - Skoda YETI Owner's Manual

Flexible storage compartment


Read and observe and
The flexible storage compartment can be installed on the right-hand side of
the boot » Fig. 112.
The storage compartment is designed for storing small objects with a maxi-
mum total weight of 8 kg.
Fitting
›
Place both ends of the storage compartment into the openings on the right
side panel of the luggage compartment.
›
Push the storage compartment down to lock it.
Removing
›
Grasp the storage compartment on the two upper corners.
›
Press the upper corners inwards and release the storage compartment by
pulling upwards.
›
Remove the storage compartment by pulling towards you.
CAUTION
The flexible storage compartment cannot be installed on vehicles with the var-
iable loading floor.

Floor covering on both sides


Read and observe and
You can fit a double-sided floor covering in the luggage compartment.
One side of the double-sided floor covering is made of fabric, the other side is
washable (easy to maintain).
The washable side is used to transport wet or dirty items.
Fig. 112
Flexible storage compartment
on page 96 first.
on page 96 first.
Note
For easier turning of the covering, use the loop attached.

Luggage compartment cover

Fig. 113 Remove the luggage compartment cover

Read and observe and
If the support straps » Fig. 113
A
the lid will raise the boot lid cover (hereafter referred to as cover).
The boot cover can be removed if you want to transport bulky goods.
Removing
›
Fold the seat backrests forward a little to make it easier to remove the lug-
gage compartment cover » page
›
On both sides of the boot lid, unhook the straps
» Fig. 113.
1
›
Place the cover in the horizontal position.
›
Press on the two sides to the underside of the cover in the region of the
studs in the direction of arrow
C
›
Fold the slackened front part of the boot cover over the head restraints of
the rear seats.
›
Slightly tilt the boot cover and remove it to the rear.
Fitting
›
Place the cover on the contact surfaces of the side trim panel.
›
Position the mounts on the cover
» Fig. 113.
›
Press on the two sides to the upper side of the cover in the region of the
studs .
C
on page 96 first.
are attached to the boot lid, then opening
81, inclination of the seat backrest.
in the direction of arrow
A
.
2
onto the side trim panel via pins
B
Transporting and practical equipment
C

99