Collector Configuration Application; Adding An Sv9100 - NEC Univerge SV9100 Installation Manual

Collector Configuration Application

The Collector Configuration Application can be used to edit connections to PBX's, for example if the
IP address of a PBX has changed, you can update the MyCalls configuration to reflect this change.
Usually this would be done using the Configuration Import tool however the Collector Configuration
Application can be used also.
The following procedures can be used to manually add a PBX into a MyCalls installation. You should
only really need to do this when it is not possible to use the config import tool. Before adding a PBX,
make sure the relevant outputs are programmed correctly on the PBX.

Adding an SV9100

When adding an SV9100, you will need to create two connections, one for P Events and one for
SMDR. From the Start/Programs/NEC Infrontia/MyCalls/ menu launch the Collector Configuration
application. At the login prompt, enter the User name 'installer' and password 'Installer' note: the
password has a capital 'I.'
Expand Collectors / Local Collector / Network Connections and click 'Create a New Network
Connection.'
116 | P a g e