Installation Procedures; Scenario 1 - Single Mycalls Pc, Multiple Pbx's With Sql Express 2008 R2 - NEC Univerge SV9100 Installation Manual

Installation Procedures

The following section describes the installation procedures for the different enterprise solutions. Each
of the following scenarios can be installed using SQL Express 2008 R2 or SQL 2008 R2. Further
information on installing MyCalls with SQL 2008 R2 is documented in the Installing MyCalls with SQL
2008 R2 section of this manual. These instructions work on the assumption that only SV9100's are
used in the installation. Instructions for adding in different PBX's into the installation are available in
the 'Collector Configuration Application' section of this manual.
Scenario 1 – Single MyCalls PC, Multiple PBX's with SQL Express 2008
R2.
The steps to installing this scenario are summarised as follows:

Make sure that all of the SV9100's in the Enterprise are programmed for MyCalls.
Refer to the MyCalls Installation guide for further details.

Carry out a complete installation on the MyCalls Server PC.

Install the MyCalls Enterprise license on the SV9100 that will hold the license.

On the MyCalls Server PC, read the license from the SV9100 holding the Enterprise
license and register it.

Install the license that will enable SMDR and P Commands on all of the other
SV9100's that are part of the enterprise.

Do the config import for the 1

Add the additional PBX's into MyCalls.

Do the config import for each PBX.
When the license is read from the SV9100, the number of PBX's will reflect the number of SV9100's
that will be monitored. The license will then need to be installed and registered.
st
site.
101 | P a g e