NEC Univerge SV9100 Installation Manual page 111

Scenario 3 – Clustered Install with Group Cluster Clients
The steps for this installation scenario are summarised as follows

Make sure that all the PBX's are programmed for MyCalls. Refer to the MyCalls
Installation guide for further details.

Install MyCalls and Elect the Cluster Server.

Install the MyCalls Enterprise license on the SV9100 that will hold the license.

On the MyCalls Cluster Server, read the license from the SV9100 holding the
Enterprise license and register it.

Install the license that will enable SMDR and P Commands on all of the other
SV9100's that are part of the enterprise.

Carry out a complete installation on the Group Cluster Client PC and configure it as a
Group Cluster Client PC.

Do the config import for each of the PBX's in the group cluster client.
Install MyCalls and Elect the Cluster Server
Follow the instructions from scenario 2 for installing MyCalls and electing the cluster server. Once
you have elected the Cluster Server, you can do the config import for the PBX connected to the
Cluster Server. Before installing and configuring the Group Cluster Clients, make sure you install the
Enterprise license.
Install and Configure Group Cluster Clients
Again this procedure is similar to that from scenario 2. On the Group Cluster Client PC, firstly carry
out a complete installation of MyCalls.
application from the C:\Program Files\NEC Infrontia\MyCalls folder.
The toolkit application will load.
Once the installation has completed, start the toolkit
111 | P a g e