Scenario 2 - Clustered Installation With A Cluster Server And Node Cluster Clients - NEC Univerge SV9100 Installation Manual

Scenario 2 – Clustered Installation with a Cluster Server and Node
Cluster Clients
The steps to installing this scenario are summarised as follows:

Make sure that all the PBX's are programmed for MyCalls. Refer to the MyCalls
Installation guide for further details.

Install MyCalls and Elect the Cluster Server.

Install the MyCalls Enterprise license on the SV9100 that will hold the license.

On the MyCalls Cluster Server, read the license from the SV9100 holding the
Enterprise license and register it.

Install the license that will enable SMDR and P Commands on all of the other
SV9100's that are part of the enterprise.

Configure and add node cluster clients as required

Do the config import for each node cluster client
Installing MyCalls
Once the PBX has been programmed for SMDR output, you should start the MyCalls installation as
normal and carry out a complete installation of MyCalls. Once the installation has completed, carry
out the configuration import for the first PBX as normal. Use the license manager to read the license
from the SV9100 and check the number of PBX's are correct. The license will then need to be
installed and registered.
104 | P a g e