Scenario 4 - A Cluster Server With Node Cluster Clients And Group Cluster Clients; Scenario 5 - Netlink Installation - NEC Univerge SV9100 Installation Manual

Scenario 4 - A Cluster Server with Node Cluster Clients and Group
Cluster Clients.
This scenario is a combination of Scenario 2 and 3, the installation steps are summarised as follows.

Install and Elect the Cluster Server

Install the MyCalls Enterprise license on the SV9100 that will hold the license.

On the MyCalls Cluster Server, read the license from the SV9100 holding the
Enterprise license and register it.

Install the license that will enable SMDR and P Commands on all of the other
SV9100's that are part of the enterprise.

Do the config import for the PBX connected to the Cluster Server

Install and configure node cluster clients

Do the config import for node cluster clients

Install and configure group cluster clients

Do the config import for the group cluster clients
To install MyCalls Enterprise in this way follow instructions from scenario 2, this will have MyCalls
installed and node cluster clients working. Then follow the instructions 'Install and Configure Group
Cluster Clients' from the installation instruction from scenario 3.
Scenario 5 – Netlink installation
A Netlink installation will look like one PBX to MyCalls. The license is slightly different to a normal
enterprise licensing rules. A MyCalls Call Manager or MyCalls Call Centre license should be installed
and then a Netlink node license for each secondary Netlink PBX. If the secondary Netlink system
exists on the same IP subnet as the primary system that a Netlink Node license is not required. As
the P Commands and SMDR are output from the Primary Netlink system, that is the only system that
needs to have a license installed on it. Where MyCalls Call Centre is used the agents can be
distributed amongst the Enterprise, regardless of if they are connecting to a Primary of Secondary
system.
Step by step instructions are as follows:

Install the MyCalls Server

Install the MyCalls license on the Primary Netlink SV9100

On the MyCalls Server, read the license from the SV9100 holding the license and
register it.

Do the config import for the Primary Netlink system
114 | P a g e