A Portion of the Page Is Not Printed
Perform one of the following solutions according to the cause.
<Cause 1> The setting for the scaling factor is not appropriate.
Perform the following procedure in the printer driver.
Solution 1
If the [Manual Scaling] check box is cleared, the scale factor will be set according to [Page Size]
and [Output Size] automatically.
Perform the following procedure in the printer driver.
Solution 2
<Cause 2> Paper is not loaded properly in the paper drawer or multi-purpose tray.
Load the paper properly.
Solution
"Loading Paper in the Paper Drawer"
"Loading Paper in the Multi-purpose Tray"
<Cause 3> A document with no margins was printed.
Data is printed with a margin of 5 mm (10 mm for envelopes). Provide a margin around the data.
Solution 1
"Printable Area"
Perform the following procedure if you are using the printer driver.
PCL/UFR II Printer Driver
Solution 2
PS Printer Driver
See Help of the PS printer driver.
The edges of the printout may be partly missing, depending on the settings of the document to be
printed.
Downloaded from ManualsPrinter.com Manuals
1. Display the [Page Setup] sheet.
2. Clear the [Manual Scaling] check box.
1. Display the [Page Setup] sheet.
2. Select the [Manual Scaling] check box, and then specify an appropriate scale factor according
to the paper size to be used.
1. Display the [Finishing] sheet.
2. Click [Advanced Settings].
3. Set [Expand Print Region and Print] to [On].
04L9-0LH