Canon i-SENSYS LBP6670dn User Manual page 290

[Enlarge/Reduce to
Fit Paper Size]
[Enlarge Print Area]
[Print 2-Sided]
[Binding Location]
[N on 1]
[Page Order]
[Finishing]
[Store in Box]
9
Click [Start Printing].
Do not keep clicking [Start Printing] while the file is transferring. Sometimes it takes time to transfer a file, but if you
keep clicking during the transfer, a file failure may occur and it may be impossible to transfer it.
When the print job has finished sending, the display switches and the following message is displayed.
Press [To Job List] to check the print job that was sent.
Downloaded from ManualsPrinter.com Manuals
If the check box is selected, it fixes the aspect ratio and scales it to fit with the effective print
area of the paper size that is set and prints. However if [Paper Size] is set as [Auto], this item
cannot be set.
Specify whether to expand the printable area and print.
Depending on the document to be printed, part of the edges of the paper may not be
printed.
Specify 1-sided or 2-sided printing.
Set the binding position on the long side of the paper (long-edged binding) or the short side of
the paper (short-edged binding). If binding is set from the printer side, the position of the
"gutter" is automatically adjusted on the front and back sides of the paper.
You can print multiple pages of the XPS file data arranged on one page.
When printing multiple pages side by side, set [Paper Size] to a setting other than [Auto].
The [N on 1] setting enables you to set the order the pages will be arranged on the paper
when printing multiple pages on one page.
(It is only displayed when an SD card is used.)
It collates and prints in page or section units.
[Off]: Print the number of copies specified for every page.
[Collate]: The specified number of copies are collated.
(It is only displayed when an SD card is used.)
When storing it in a box, check the [Store in Box] check box before selecting the box where
you want to store it.