Setup] Menu ([Network] Options) - Canon i-SENSYS LBP6670dn User Manual

[Setup] Menu ([Network] Options)

NOTE
Table description
After changing the settings for this item, cycle the power of the printer or perform a hard reset to make the settings
effective.
This item is displayed only when all the following conditions are met.
[Network] in [Interface Selection] is set to [On].
Bold values in the table indicate the default settings.
The setting items or setting values with "*" may not be displayed depending on the availability of the optional
accessories and other settings.
Setting Item
[TCP/IP Settings]
[IPv4 Settings]
Downloaded from ManualsPrinter.com Manuals
Setting Value
[IPv4]: [Off], [On]
[IP Mode]: [Auto],
[Manual]
*
:
[Protocol]
[Use DHCP]:
[Off], [On]
[Use BOOTP]:
[Off], [On]
[Use RARP]:
[Off], [On]
[IP Address Settings]:
[IP Address]:
0.0.0.0
[Subnet Mask]:
0.0.0.0
[Gateway
Address]: 0.0.0.0
[DNS]:
[Primary Address]:
0.0.0.0
[Secondary
Address]: 0.0.0.0
[DHCP Option]:
[Acquire Host
Name]: [Off],
[On]
[DNS Dynamic
Update]: [Off],
[On]
Specifies the TCP/IP setting for the print server equipped with this
printer.
When using IPv4, set it to [On].
Select the method for setting the IP address.
When setting the IP address using any one of DHCP, BOOTP,
or RARP, select [Auto].
When specifying the IP address to the printer directly, select
[Manual].
If you set [IP Mode] to [Auto], select which protocol you want to use.
Set each of [Use DHCP], [Use BOOTP], and [Use RARP] to [On]
(use) or [Off] (do not use).
Specify [IP Address], [Subnet Mask], and [Gateway Address]. For
the method for entering the addresses, see
addresses" below the table.
Specify [Primary Address] and [Secondary Address] for DNS.
For the method for entering the addresses, see
addresses" below the table.
*
Specify the settings for [Host Name], [Domain Name], and
[DNS Dynamic Update] from the Remote UI.
"Configuring the Protocol Settings"
Set DHCP options when [IP Mode] is set to [Manual] and [Use
DHCP] is set to [On].
When obtaining the host name using DHCP, set [Acquire Host
Name] to [On].
When updating the host name using DHCP, set [DNS Dynamic
Update] to [On].
If you want to use IP v. 6, specify [On].
Setting
"Method for entering
"Method for entering
04L9-0AC