Loading Documents - BELGACOM Belgafax 710 User Manual

Loading Pre-printed Material
If you would like to print on pre-printed material (e.g.
forms, stationary), place the pre-printed material in the
paper tray up to the stop with the printed side facing
down.
If you are using pre-printed material with a letterhead,
place the paper into the paper tray with the top edge
in first.
Loading Envelopes
Insert the envelopes into paper tray with the flap facing
upward and the short side out until reaching the stop.
Also enclose smaller envelope formats with the tab on
the front paper guide.
Inserting Transparencies
Insert the transparencies into the paper tray with the
printing side (= rough side) facing down until reaching
the stop. Only use transparencies that are intended for
use with inkjet printers.

Loading Documents

Æ
Do not place any documents on the scanner
that are wet or to which correction fluid has
been applied! Make sure that the scanner glass is
clean (see chapter Troubleshooting / Cleaning
and Care).
1 Open the scanner cover.
1. Installation
2 Lay the document onto the scanner glass with the
written side down.
3 Align the document with the rear left corner of the
scanner glass (arrow marks).
4 The markings on the scanner border for the A4 and
A5 formats will help you to position the document
correctly.
5 Close the scanner cover.
²
The scanner cover is equipped with adjust-
able hinges, allowing you to lay even thicker
documents (e.g. books) in the flatbed scanner.
Carefully lift the scanner cover so that it rests as
evenly as possibly.
Use clear sheets of plastic when copying three-
dimensional objects (e.g. coins, flowers) to avoid
damaging the scanner glass.
13