Table of Contents
Advertisement
Use / to select the resolution that you would like
2
to use as the new standard setting for fax transmis-
sion. Confirm with OK.
Suppressing the Header
If you do not want your sender identification (= header)
to appear on outgoing messages, you can suppress the
display of the header:
Æ
Please note that many recipients have config-
ured their machines to reject messages with-
out sender identification.
Press MENU/OK and 272.
1
Use / to select OFF, and confirm with OK. The
2
header will be suppressed.
Setting the Transmission
Speed
If you frequently send messages to networks with poor
line quality, you can reduce the transmission speed.
Æ
A slower transmission speed ensures better
transmission quality, but increases the time
required for the transmission.
Press MENU/OK and 273.
1
Use / to select the desired transmission speed.
2
Confirm with OK.
Echo Protection
Particularly for transmissions overseas, feedback (= echo)
can result in disruptions. Activate the echo protection
to ensure flawless transmission.
Æ
Transmission with echo increases the trans-
mission time. However, the data are transmit-
ted with greater reliability.
Press MENU/OK and 274.
1
Use / to select ON and confirm with OK. The
2
echo protection is activated.
Display Information
Configure which information should be shown on the
display during transmission.
Press MENU/OK and 276.
1
Use / to select one of the following options:
2
speed—The transmission speed is displayed
page number—The page number of the page cur-
rently being sent is displayed
3
Confirm with OK.
8. Fax
Printing a Time Stamp
Your multifunction machine prints an additional re-
ceipt stamp (= time stamp) on the lower edge of incom-
ing fax transmissions. You have the option of turning
this function off.
Press MENU/OK and 277.
1
Use / to select off. To activate it, select on.
2
Confirm with OK
Reception Speed
If you frequently receive fax messages from networks
with poor line quality, you can reduce the reception
speed.
Press MENU/OK and 278.
1
Use / to select the desired reception speed. Con-
2
firm with OK.
E.C.M.
Your multifunction machine is equipped with Er-
ror Correction Mode (E.C.M.). E.C.M. prevents data
losses resulting from poor telephone lines by requesting
faulty data packets again. E.C.M. must be supported by
both the transmitting and receiving machines.
Æ
With the standard settings, E.C.M. is acti-
vated because this does not result in increased
telephone charges when the telephone lines are
good.
Press MENU/OK and 279.
1
Use / to select OFF and confirm with OK.
2
E.C.M. is deactivated.
²
Return to the last menu entry with C; return
to the starting mode with X.
35
Advertisement
Table of Contents
