Installing The Control Panel-10 Hard Drive System - Dell PowerEdge R620 Owner's Manual
Owner's manual
Hide thumbs
Also See for PowerEdge R620:
- Owner's manual (141 pages) ,
- Technical manual (58 pages) ,
- Getting started manual (12 pages)
Table of Contents
Advertisement
Figure 50. Removing and Installing the Control Panel
1. control panel release latch
2. J_CP connector on system board
3. control panel cable connecting to system board
4. J_FP_USB connector on system board
5. cable securing clip
6. screw
7. control panel
Installing The Control Panel—10 Hard Drive System
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1.
Route the control panel cable through the chassis and connect the control panel cable to the control panel.
2.
Push the control panel into the chassis till it snaps into place.
3.
Using a #1 Philips screwdriver, replace the screw (located at the bottom of the chassis) that secures the control
panel to the chassis.
4.
Locate the connectors J_CP and J_FP_USB on the system board.
91
Advertisement
Table of Contents
Troubleshooting
