Installing The Control Panel-10 Hard-Drive System - Dell E14S Series Owner's Manual

Figure 36. Removing and installing the control panel
1. control panel release latch
3. control panel cable connecting to system
board
5. screw
Installing the control panel–10 hard–drive system
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Keep the #1 Philips screwdriver ready.
Steps
1. Route the control panel cable through the chassis and connect the control panel cable to the
control panel.
2. Push the control panel into the chassis till it snaps into place.
3. Using a #1 Philips screwdriver, replace the screw (located at the bottom of the chassis) that secures
the control panel to the chassis.
4. Locate the connectors J_CP and J_FP_USB on the system board.
NOTE: To locate the connectors on the system board, see System Board Connectors.
2. cable securing clip
4. J_FP_USB connector cable
6. control panel
91