Installing The Control Panel-10 Hard Drive System And 24 Hard Drive System - Dell PowerEdge R630 Owner's Manual

3. Slide the control panel out of the chassis.
4. Disconnect the control panel cable from the control panel.
Figure 91. Removing the control panel for 10 and 24 hard drive system
1. control panel
3. screw
5. J_CP connector on the system board
Related references
Safety instructions
System board jumpers and connectors
Related tasks
Before working inside your system
Installing the control panel–10 hard drive system and 24 hard drive system
Installing the control panel–10 hard drive system and 24 hard drive
system
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Keep the Philips #1 screwdriver ready.
1. Route the control panel cable through the chassis and connect the control panel cable to the control panel.
2. Push the control panel into the chassis till it snaps into place.
NOTE: Ensure that the screw hole on the control panel aligns with the screw hole located at the top of the chassis.
142 Installing and removing system components
2. screw hole
4. cable securing clip
6. J_FP_USB connector on the system board