Paper Size Not Detected; Insufficient Paper For Job - Canon iPF6400S User Manual

Paper size not detected.

When Detect Mismatch in the Control Panel menu is set
to Pause or Hold Job, the width of the loaded roll does
not match the width specified in Fit Roll Paper Width in
the printer driver.
Paper size not detected.
Paper size not detected.
Paper has been loaded askew, or warped paper has been loaded.

Insufficient paper for job

Insufficient paper for job
The printer has received a print job longer than the amount of roll paper left when
ManageRemainRoll in the Control Panel menu is On.
904
Cause
Cause
Cause
Corrective Action
However, note that this error may cause paper jams and affect the printing
quality.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Follow these steps to replace the roll to match the width specified in the print-
er driver.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.")
(See "Removing Rolls From the Roll Holder.")
2.
Replace with paper of the width configured in the printer driver.
(See "Loading Rolls on the Roll Holder.")
(See "Loading Rolls in the Printer.")
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box displayed when you select
Fit Roll Paper Width in the printer driver matches the width of the roll loaded
in the printer, and then try printing again.
Press the OK button and reload the paper.
(See "Loading Rolls in the Printer.")
(See "Loading Sheets in the Feed
Slot.")
If "Not finished printing. Finish printing re-
maining jobs?" is displayed on the Display
Screen, press the OK button.
Printing will resume, starting from the page
on which the error occurred.
If this error recurs after you reload the roll, re-
move the Roll Holder from the printer, push
the roll firmly in until it touches the Roll Holder
flange, and reload the Roll Holder in the print-
er.
(See "Loading Rolls on the Roll Hold-
er.")
Press ▲ or ▼ to select Print, and then press the
OK button to resume printing.
However, the roll paper may run out during the print
job and you may not be able to print all of the docu-
ment.
Press ▲ or ▼ to select Change Paper, and then
press the OK button.
Change the Paper Source of the printer driver, or
replace the roll with a roll that has enough paper for
the print job, and then print.
(See "Removing the Roll from the Printer.")
(See "Loading Rolls in the Printer.")
Press ▲ or ▼ and select Stop Printing or press
the Stop button to stop printing.
iPF6400S
P.478
➔
P.480
➔
P.471
➔
P.473
➔
Corrective Action
➔
P.495
➔
P.471
➔
Corrective Action
P.473
➔
P.473
P.478
➔
User's Guide